DTC 01-DF Master Error |
| DTC No. | DTC Detection Condition | Trouble Area |
| 01-DF *1 |
|
|
| 1.CHECK NAVIGATION RECEIVER ASSEMBLY POWER SOURCE CIRCUIT |
| NEXT | |
| 2.INSPECT NAVIGATION RECEIVER ASSEMBLY |
![]() |
Disconnect the navigation receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ATX+ (R15-5) - ATX- (R15-15) | Always | 60 to 80 Ω |
| TXM+ (R14-9) - TXM- (R14-10) | Always | 60 to 80 Ω |
|
| ||||
| OK | |
| 3.IDENTIFY THE COMPONENT WHICH HAS STORED THIS CODE |
![]() |
Enter the diagnostic mode.
Press the "LAN Mon" switch to change to "LAN Monitor" mode.
Identify the component which has stored this code.
| Display | Component |
| Rr-TV | Television display assembly |
| DSP-AMP | Stereo component amplifier |
| NEXT | |
| 4.CHECK HARNESS AND CONNECTOR |
Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the navigation receiver assembly and the component which has stored this code.
Disconnect all connectors between the navigation receiver assembly and the component which has stored this code.
Check for an open or short in the AVC-LAN circuit between the navigation receiver assembly and the component which has stored this code.

|
| ||||
| OK | |
| 5.REPLACE NAVIGATION RECEIVER ASSEMBLY |
Replace the navigation receiver assembly with a normal one and check if the same problem occurs again.
|
| ||||
| OK | ||
| ||