Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > Tire Pressure Warning Light Circuit

for Preparation Click here


DESCRIPTION

If the tire pressure warning ECU detects a disconnected connector or an open circuit between the tire pressure warning ECU and combination meter, the tire pressure warning light turns off 10 seconds after the ignition switch is turned ON, blinks for 1 minute, and then remains on. Connecting terminals TC and CG of the DLC3 makes the tire pressure warning light blink and output the DTC.

WIRING DIAGRAM


C174781E04


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using Techstream and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU after the ECU and/or tire pressure warning valve and transmitter has been replaced.

1.PERFORM ACTIVE TEST USING TECHSTREAM (COMBINATION METER)
  1. Turn the ignition switch OFF.

  1. Connect Techstream to the DLC3.

  1. Turn the ignition switch ON and the tester ON.

  1. Enter the following menus: Body / Combination Meter / Active Test.

  1. Check the condition of the tire pressure warning light by operating the tester.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. Tire Pressure Warning System
    Tire Pressure Warning Light illuminates
    ON or OFF
    -

    OK:
    The warning light turns on when operating the tester.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (COMBINATION METER - ECU)
  1. Disconnect the T15 ECU connector.

  1. Disconnect the C10 meter connector.



    C158878E06
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    T15-5 (IND) - C10-6 (TIRE)
    Always
    Below 1 Ω
    T15-5 (IND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

CHECK ECU POWER SOURCE CIRCUIT (Click here)