CHASSIS > GENERAL MAINTENANCE |
| 1. INSPECT STEERING LINKAGE |
Check the steering linkage for looseness or damage.
Check that:
Inspect the dust cover for damage.
| 2. INSPECT STEERING GEAR HOUSING OIL |
Check the steering gear housing for oil leakage.
If leakage is found, check for cause and repair it.
| 3. INSPECT DRIVE SHAFT BOOTS |
Inspect the drive shaft boots for clamp looseness, grease leakage or damage.
| 4. INSPECT BALL JOINT AND DUST COVERS |
![]() |
Inspect the ball joints for excessive looseness.
Jack up the front of the vehicle and place wooden blocks with a height of 180 to 200 mm (7.09 to 7.87 in.) under the front tires.
Lower the jack until there becomes about half a load on the front coil spring. Place stands under the vehicle for safety.
Check that the front wheels are pointing straight ahead and block them with chocks.
Using a lever, pry up the end of the lower arm and check the amount of play.
![]() |
Check the dust cover for damage.
| 5. INSPECT TRANSAXLE FLUID |
| 6. INSPECT TRANSFER OIL (for 4WD) |
| 7. INSPECT REAR DIFFERENTIAL OIL (for 4WD) |
| 8. TIGHTEN BOLTS FOR PROPELLER SHAFT (for 4WD) |
| 9. ROTATE TIRES |