Home › ENGINE › 2GR-FE COOLING › WATER PUMP

WATER PUMP > REMOVAL

for Preparation Click here



1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
Click here



2. SECURE ENGINE
  1. Secure the engine onto an engine stand with the bolts.



    A129635E12
  1. Remove the engine hangers.



3. REMOVE GENERATOR ASSEMBLY


    A162681
  1. Remove the terminal cap.

  1. Remove the nut and disconnect the wire harness from terminal B.

  1. Disconnect the generator connector from the generator assembly.

  1. Disconnect the connector from the compressor and magnetic clutch.

  1. Disconnect the 2 wire harness clamps.



    A162682
  1. Remove the 2 bolts.



    A162683E01
  1. Remove the bolt from the cylinder block.

  1. Disconnect the wire harness clamp and remove the generator assembly.



    A162684
  1. Remove the bolt and wire harness clamp stay.



    A162685
  1. Remove the bolt and bracket.



4. REMOVE COMPRESSOR AND MAGNETIC CLUTCH
  1. Disconnect the connector.

  1. Release the 2 clamps and wire harness.



    E145255
  1. Remove the 2 bolts and 2 nuts.



    E145254
  1. Using a "TORX" socket wrench (E8), remove the 2 stud bolts and the compressor and magnetic clutch.



5. REMOVE NO. 1 ENGINE FRONT MOUNTING BRACKET LH


    A129646
  1. Remove the 6 bolts and No. 1 engine front mounting bracket LH.



6. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY


    A195781E01
  1. Remove the 2 bolts, 2 idler pulley cover plates, 2 No. 2 idler pulley cover plates and 2 No. 2 idler pulley sub-assemblies.

    HINT:
    Plate diameter:
    Idler pulley cover plate: 33.6 mm (1.32 in.)
    No. 2 idler pulley cover plate: 37.8 mm (1.49 in.)



7. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY


    A161449
  1. Remove the 5 bolts and V-ribbed belt tensioner assembly.



8. REMOVE WATER PUMP PULLEY


    A128112E03
  1. Using SST, hold the water pump pulley.

    SST
    09960-10010   (09962-01000, 09963-00700)

  1. Remove the 4 bolts and water pump pulley.



9. REMOVE WATER INLET HOUSING


    A133375E04
  1. Disconnect the water hose.

  1. Remove the 2 bolts, nut and water inlet housing.



    A128120
  1. Remove the water inlet housing gasket and water outlet pipe O-ring.



10. REMOVE WATER PUMP ASSEMBLY


    A094889
  1. Remove the 16 bolts, water pump assembly and water pump gasket.