Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function)

POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function) > Power Window cannot be Operated by Wireless Operation

for Preparation Click here


DESCRIPTION

When the switch on the transmitter is operated during normal operating conditions (Click here), the multiplex network body ECU sends a request signal to the master switch and the regulator switches which then drive the applicable power window motors.

INSPECTION PROCEDURE

1.CHECK WIRELESS DOOR LOCK CONTROL FUNCTIONS
  1. Check that the wireless door lock functions operate with movement of the transmitter switch.

    HINT:
    When the wireless door LOCK/UNLOCK operation can be performed, it means that the wireless signal from the transmitter is properly input to the multiplex network body ECU.



NG
CHECK WIRELESS DOOR LOCK CONTROL FUNCTIONS
OK


2.CHECK MANUAL UP/DOWN FUNCTION
  1. Check that the manual UP/DOWN function using the master switch and each regulator switch can operate all the power windows.



NG
OTHER PROBLEM
OK


3.CHECK REMOTE UP/DOWN FUNCTION
  1. Check that the remote UP/DOWN function using the master switch can operate the power windows.



NG
OTHER PROBLEM
OK

REPLACE MULTIPLEX NETWORK BODY ECU