Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › MULTIPLEX COMMUNICATION SYSTEM

MULTIPLEX COMMUNICATION SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Troubleshoot in accordance with the procedures on the following pages.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.DTC CHECK
    1. Check for DTCs and make a note of the code that is output (Click here).

    2. Delete the DTC.

    3. Check if the DTC is output once again when the problem symptom is simulated based on the noted code.

      1. When no code is output (symptom check and simulation are possible), proceed to A.

      2. When a code is output, proceed to B.



    B.
    Go to step 4
    A


    3.PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM
    1. Terminals of ECU (Click here)



    4.ADJUST, REPAIR OR REPLACE

      NEXT

      END