Home › DRIVE LINE › MF2A TRANSFER › EXTENSION HOUSING OIL SEAL

EXTENSION HOUSING OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL TRANSFER EXTENSION HOUSING TYPE T OIL SEAL


    C083633E01
  1. Using SST(s), install anew transfer extension housing type T oil seal to he transfer extension housing sub-assembly at the position show in the illustration.

    SST
    09325-20010  

    NOTICE:
    Do not install the oil seal obliquely.

  1. Apply small amount of MP grease to the oil seal lip.



2. TEMPORARILY TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

HINT:
(Click here)



3. FULLY TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

HINT:
(Click here)



4. INSTALL FRONT EXHAUST PIPE ASSEMBLY

HINT:
(Click here)



5. INSTALL TRANSFER DRAIN PLUG
  1. Install the transfer drain plug with anew drain gasket.

    Torque:
    49 N*m{ 50 kgf*cm , 36 ft.*lbf }



6. INSTALL TRANSFER CASE NO.1 PLUG
  1. Add oil up to 0 to 5 mm (0 to 0.20 in.) below the lower side of the plug hole.

    Oil amount:
    0.9 L (0.95 US qts, 0.71 lmp.qts)

    NOTICE:
    When supplying oil, pour do it slowly.

  1. Install the transfer case No. 1 plug with a new gasket No. 1.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



7. CHECK FOR EXHAUST GAS LEAK