Home › DRIVE LINE › MF2A TRANSFER › EXTENSION HOUSING OIL SEAL

EXTENSION HOUSING OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE TRANSFER CASE NO.1 PLUG


    C082977E01
  1. Remove the No. 1 transfer case plug.

  1. Remove the No. 1 gasket from the transfer case No. 1 plug.



2. REMOVE TRANSFER DRAIN PLUG
  1. Remove the transfer drain plug, drain gasket and bleed transfer oil.



3. REMOVE EXHAUST PIPE ASSEMBLY

HINT:
(Click here)



4. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

HINT:
(Click here)



5. REMOVE TRANSFER EXTENSION HOUSING TYPE T OIL SEAL


    C083632E03
  1. Using SST(s), remove the transfer extension housing type T oil seal from the transfer extension housing sub- assembly.

    SST
    09308-00010  

    NOTICE:
    Be careful not to damage the oil-seal-fitted surface and the inside surface of the bush.