Home › DRIVE LINE › DIFFERENTIAL › REAR DIFFERENTIAL CARRIER OIL SEAL

REAR DIFFERENTIAL CARRIER OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL REAR DIFFERENTIAL DRIVE PINION BEARING SPACER
  1. Install a new bearing spacer.



2. INSTALL REAR DRIVE PINION FRONT TAPERED ROLLER BEARING
  1. Install the tapered roller bearing.



3. INSTALL REAR DIFFERENTIAL DRIVE PINION OIL SLINGER


    C083862
  1. Install the oil slinger, as shown in the illustration.



4. INSTALL REAR DIFFERENTIAL CARRIER OIL SEAL


    G025655E03
  1. Using SST and a hammer, install a new oil seal.

    SST
    09554-22010  

    Oil seal drive in depth:
    2.0 +- 0.3 mm (0.079 +- 0.012 in.)

  1. Coat MP grease to the oil seal lip.



5. INSTALL REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY


    D030957E02
  1. Using SST, install the companion flange on the shaft.

    SST
    09950-30012   (09951-03010, 09953-03010, 09954-03010, 09955-03030, 09956-03020)

    NOTICE:
    Apply hypoid gear oil to the SST center bolt tip and threads before use.



6. INSTALL REAR DRIVE PINION NUT
  1. Coat the threads of a new nut with hypoid gear oil LSD.



    D030847E01
  1. Using SST to hold the flange, torque the nut.

    SST
    09330-00021  

    Torque:
    108 N*m{ 1,100 kgf*cm , 80 ft.*lbf }



7. INSPECT DIFFERENTIAL DRIVE PINION PRELOAD
  1. Inspect differential drive pinion preload .

  1. Using a chisel and a hammer, stake the drive pinion nut.



8. INSTALL REAR DIFFERENTIAL DRAIN PLUG
  1. Using a hexagon wrench (10 mm), install the filler plug with a new gasket.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



9. ADD DIFFERENTIAL OIL
  1. Fill the rear differential carrier assembly with hypoid gear oil.



10. INSPECT DIFFERENTIAL OIL

HINT:
(Click here)



11. INSTALL REAR DIFFERENTIAL FILLER PLUG
  1. Using a hexagon wrench (10 mm), install the filler plug with a new gasket.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



12. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
  1. Install propeller with center bearing shaft assembly .

  1. Fully tighten propeller with center bearing shaft assembly .



13. INSTALL EXHAUST PIPE ASSEMBLY

HINT:
(Click here)



14. INSPECT FOR EXHAUST GAS LEAK

HINT: