REAR DIFFERENTIAL CARRIER OIL SEAL > REMOVAL |
| 1. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
| 2. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY |
| 3. REMOVE REAR DIFFERENTIAL FILLER PLUG |
Using a hexagon wrench (10 mm), remove the filler plug and gasket.
| 4. REMOVE REAR DIFFERENTIAL DRAIN PLUG |
Using a hexagon wrench (10 mm), remove the drain plug and gasket, and drain the oil.
| 5. REMOVE REAR DRIVE PINION NUT |
Using a chisel and a hammer, unstake the staked part of the nut.
![]() |
Using SST to hold the flange, remove the nut.
| 6. REMOVE REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY |
![]() |
Using SST, remove the companion flange.
| 7. REMOVE REAR DIFFERENTIAL CARRIER OIL SEAL |
![]() |
Using SST, remove the oil seal.
| 8. REMOVE REAR DIFFERENTIAL DRIVE PINION OIL SLINGER |
| 9. REMOVE REAR DRIVE PINION FRONT TAPERED ROLLER BEARING |
![]() |
Using SST, remove the front tapered roller bearing.
| 10. REMOVE REAR DIFFERENTIAL DRIVE PINION BEARING SPACER |