Home › BRAKE › BRAKE › BRAKE BOOSTER

BRAKE BOOSTER > REMOVAL

for Preparation Click here


NOTICE:
  1. Do not adjust the brake booster push rod.
  2. Do not change the combination of the diameter converting unit and brake.
  3. Release the vacuum from the booster by depressing the brake pedal several times. Then remove the brake master cylinder from the brake booster.



1. REMOVE FRONT WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
Wash the brake fluid off immediately if it adheres to any painted surfaces.



3. SEPARATE BATTERY NEGATIVE TERMINAL


4. REMOVE FRONT DOOR SCUFF PLATE LH


5. REMOVE COWL SIDE TRIM BOARD LH
  1. Remove the nut and cowl trim board plate LH.



6. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER LH
  1. Remove the 2 bolts and instrument panel finish panel sub-assembly lower LH.



7. REMOVE INSTRUMENT PANEL SAFETY PAD INSERT SUB-ASSEMBLY NO. 1
  1. Remove the 4 bolts and instrument panel safety pad insert sub-assembly No. 1.



8. REMOVE COWL TOP PANEL SUB-ASSEMBLY OUTER FRONT

HINT:
When removing or installing the front shock absorber with coil spring RH, it is necessary to remove the cowl top panel sub-assembly outer front.

  1. Disconnect the wire harness from the cowl top panel sub-assembly outer front.



    F049306E01
  1. Remove the 9 bolts, cowl top brace and cowl top panel sub-assembly outer front.



9. REMOVE AIR CLEANER ASSEMBLY WITH HOSE


10. REMOVE BRAKE ACTUATOR ASSEMBLY (w/o VSC)
SST
09023-00101  

HINT:
Click here.



11. REMOVE ABS & TRACTION ACTUATOR ASSEMBLY (w/ VSC)
SST
09023-00101  

HINT:
Click here.



12. REMOVE BRAKE LINE
  1. Remove the front brake tube No. 1, front brake tube No. 2, front brake tube No. 3 and front brake tube No. 4.

  1. Remove the rear brake tube No. 1 and rear brake tube No. 2.



13. REMOVE PUSH ROD PIN
  1. Remove the push rod pin from the brake booster push rod.



14. REMOVE BRAKE MASTER CYLINDER ASSEMBLY
  1. Slide the clip and disconnect the brake master cylinder reservoir hose from the brake master cylinder union.

  1. Slide the clip and disconnect the vacuum hose from the brake vacuum check valve assembly.



    G024262
  1. Remove the 4 nuts and clevis.

  1. Pull out the brake booster with master cylinder.



15. REMOVE BRAKE BOOSTER GASKET
  1. Remove the brake booster gasket from the brake booster with master cylinder.



16. REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY
  1. Remove the brake vacuum check valve assembly and check valve grommet from the brake booster assembly.