FRONT BRAKE > REASSEMBLY |
| 1. INSTALL FRONT DISC |
![]() |
Aligning the matchmarks, install the front disc.
| 2. INSPECT DISC RUNOUT |
Inspect the front axle hub bearing backlash and deviation (Click here).
Install the disc with the 5 hub nuts.
![]() |
Using a dial indicator, measure the disc runout 10 mm (0.39 in.) away from the outer edge of the disc.
Remove the 5 hub nuts.
| 3. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG |
Temporarily install the front disc brake bleeder plug to the front disc brake cylinder sub-assembly.
| 4. INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP |
| 5. INSTALL PISTON SEAL |
![]() |
Apply a light layer of lithium soap base glycol grease to the entire circumference of a new piston seal.
Install the piston seal to the front disc brake cylinder sub-assembly.
| 6. INSTALL FRONT DISC BRAKE PISTON |
![]() |
Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot.
Install the cylinder boot to the front disc brake piston.
Apply a light layer of lithium soap base glycol grease to the contact surfaces of the front disc brake piston, and install it to the front disc brake cylinder sub-assembly.
| 7. INSTALL CYLINDER BOOT |
![]() |
Install the cylinder boot to the front disc brake cylinder sub-assembly.
Using a screwdriver, install the set ring.
| 8. INSTALL FRONT DISC BRAKE BUSH DUST BOOT |
Using soft jaws on a vise, hold the front disc brake cylinder mounting LH in the vise through aluminum plates.
Place the front disc brake cylinder mounting LH in the vise.
![]() |
Apply a light layer of lithium soap base glycol grease to the contact and inner surfaces of 2 new front disc brake bush dust boots.
![]() |
Using a socket wrench (19 mm) and hammer, drive the 2 front disc brake bush dust boots to the front disc brake cylinder mounting LH.