CAN COMMUNICATION SYSTEM > Steering Angle Sensor Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Steering Angle Sensor Communication Stop Mode |
|
|

| 1.CHECK OPEN IN CAN BUS WIRE (STEERING ANGLE SENSOR BRANCH WIRE) |
Turn the ignition switch off.
Disconnect the steering angle sensor connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S9-10 (CANH) - S9-9 (CANL) | Ignition Switch off | 54 to 69 Ω |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (BAT, IG1, ESS) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S9-2 (ESS) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S9-3 (BAT) - Body ground | Always | 10 to 14 V |
| S9-1 (IG1) - Body ground | Ignition Switch on | 10 to 14 V |
|
| ||||
| OK | ||
| ||