Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR AND MAGNETIC CLUTCH

COMPRESSOR AND MAGNETIC CLUTCH > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Turn the A/C switch to ON.

  1. Operating the cooler compressor at the engine rpm of approx. 1,000 for 5 to 6 minutes, circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor as much as possible.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.



2. REMOVE FRONT WHEEL RH


3. REMOVE FRONT FENDER APRON SEAL RH


    A162371
  1. Remove the 2 bolts, clip and front fender apron seal RH.



4. REMOVE V-RIBBED BELT


    A162386E01
  1. Using SST, release the belt tension by turning the belt tensioner counterclockwise, and remove the V-ribbed belt from the belt tensioner.

    SST
    09249-63010  



    A095070
  1. While turning the belt tensioner counterclockwise, align with its holes, and then insert the 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner.



5. REMOVE RADIATOR AND FAN ASSEMBLY
(Click here)


6. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY


    E145264
  1. Remove the bolt and disconnect the discharge hose sub-assembly from the compressor and magnetic clutch.

  1. Remove the O-ring from the discharge hose sub-assembly.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.



7. DISCONNECT SUCTION HOSE SUB-ASSEMBLY


    E145265
  1. Remove the bolt and disconnect the suction hose sub-assembly from the compressor and magnetic clutch.

  1. Remove the O-ring from the suction hose sub-assembly.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.



8. REMOVE COMPRESSOR AND MAGNETIC CLUTCH
  1. Disconnect the connector.

  1. Release the 2 clamps and wire harness.



    E145255
  1. Remove the 2 bolts and 2 nuts.



    E145254
  1. Using a "TORX" socket wrench (E8), remove the 2 stud bolts and the compressor and magnetic clutch.