Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM

WIRELESS DOOR LOCK CONTROL SYSTEM > No Answer-Back (Hazard Warning Light and Wireless Door Lock Buzzer)

for Preparation Click here


DESCRIPTION

If there is no answer-back of the hazard light signal and the wireless door lock buzzer although the wireless control function is operating normally, there might be a malfunction in the hazard light signal and the wireless door lock buzzer signal which are output from the multiplex network body ECU.

NOTICE:
Troubleshooting should be started after confirming that the answer-back function has been switched ON through customization.


WIRING DIAGRAM


B125109E04


INSPECTION PROCEDURE

1.CHECK WIRELESS DOOR LOCK CONTROL SYSTEM
  1. Check whether the wireless door lock functions by operating the transmitter switch (Click here).

    HINT:
    When the wireless door LOCK/UNLOCK operation can be performed, it means that the wireless signal from the transmitter is properly input to the multiplex network body ECU.


    Result 
    Result
    Proceed to
    Answer-back functions do not operate
    A
    Wireless door lock function do not operate
    Go to "Only Wireless Door Lock Control Function Does Not Operate" (Click here)


A


2.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch ON and push the Techstream main switch ON.

  1. Select the item "HAZARD" in the ACTIVE TEST and check the turn signal flasher relay ON/OFF.

  1. Select the item "BUZZ RESP SOUND" in the ACTIVE TEST and check the wireless buzzer ON/OFF.

    BODY: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Hazard
    Turn signal flasher relay
    ON / OFF
    Observe headlight and rear combination light for correct operation
    Wireless Buzzer
    Wireless door lock buzzer
    ON / OFF
    Buzzer can be heard

    Result 
    Result
    Proceed to
    Wireless door lock buzzer does not sound correctly
    A
    Hazard warning lights do not flash correctly
    B
    Wireless door lock buzzer and hazard warning lights work correctly
    C



A
Go to step 4

C
REPLACE MULTIPLEX NETWORK BODY ECU
B


3.CHECK HAZARD WARNING LIGHTS
  1. Check that the hazard warning lights blink when the hazard warning signal switch is pressed.



NG
GO TO LIGHTING SYSTEM
OK

REPLACE MULTIPLEX NETWORK BODY ECU 

4.INSPECT WIRELESS DOOR LOCK BUZZER


    B030785
  1. Check the buzzer resistance.

    NOTICE:
    1. The buzzer circuit is built into the ECU, not into the buzzer itself.
    2. When battery voltage is directly applied to the buzzer, the buzzer does not sound.

    1. Check the resistance between terminals of the buzzer.

      Standard:
      Terminal No.
      Specified Condition
      1 - 2
      Approx. 1kΩ



NG
REPLACE WIRELESS DOOR LOCK BUZZER
OK


5.CHECK HARNESS AND CONNECTOR (WIRELESS DOOR LOCK BUZZER - MULTIPLEX NETWORK BODY ECU)


    B068692E01
  1. Disconnect the K1 buzzer connector and B8 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Terminal No.
    Specified Condition
    K1-1 - BZR (B8-2)
    Below 1 Ω
    BZR (B8-2) - Body ground
    10 kΩ or higher
    K1-2 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MULTIPLEX NETWORK BODY ECU