Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

ANTI-LOCK BRAKE SYSTEM > Brake Warning Light does not Come ON

for Preparation Click here


WIRING DIAGRAM

Click here.

INSPECTION PROCEDURE

1.INSPECT BRAKE WARNING LIGHT
  1. Disconnect the skid control ECU connector.

  1. Turn the ignition switch to the on position.

  1. Check that the BRAKE warning light comes on.

    OK:
    BRAKE warning light comes on.

HINT:
If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step before replacing the part (Click here).



NG
Go to step 2
OK

REPLACE BRAKE ACTUATOR ASSEMBLY 

2.CHECK HARNESS AND CONNECTOR (BETWEEN SKID CONTROL ECU AND COMBINATION METER ASSEMBLY)
  1. Turn the ignition switch off.

  1. Disconnect the combination meter connector.



    C111162E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    S3-19 (BRL) - C10-14
    Below 1 Ω
    S3-19 (BRL) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT COMBINATION METER ASSEMBLY
  1. Check the combination meter assembly (Click here).

HINT:
If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step before replacing the part (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY
OK

END