Home › SUSPENSION & AXLE › AXLE › REAR AXLE HUB AND BEARING (for 4WD)

REAR AXLE HUB AND BEARING (for 4WD) > INSTALLATION

for Preparation Click here



1. INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH


    C065991E02
  1. Install the hub & bearing assembly LH with new 4 nuts.

    Torque:
    67 N*m{ 683 kgf*cm , 49 ft.*lbf }



2. INSPECT BEARING BACKLASH


    C083015E04
  1. Using a dial gauge, check for backlash near the center of the axle hub.

    Maximum:
    0.05 mm (0.0020 in.)

    If backlash exceeds the maximum, replace the axle hub assembly.

    NOTICE:
    Ensure that the dial gauge is set at right angles to the measurement surface.



3. INSPECT AXLE HUB DEVIATION


    C083016E04
  1. Using a dial gauge, check for deviation in the surface of the axle hub outside the hub bolt.

    Maximum:
    0.07 mm (0.0027 in.)

    If backlash exceeds the maximum, replace the axle hub assembly.

    NOTICE:
    Ensure that the dial gauge is set at right angles to the measurement surface.



4. INSTALL REAR DRIVE SHAFT ASSEMBLY LH


    C097746E01
  1. Install the drive shaft to the axle carrier.

    NOTICE:
    Be careful not to damage the boot and ABS speed sensor rotor to the drive shaft and oil seal of the axle hub bearing.

  1. Align the matchmarks and connect the drive shaft to the side gear shaft.

    NOTICE:
    Be careful not to damage the boots and end cover.

  1. Install the drive shaft with the 4 nuts and washers.

    Torque:
    56 N*m{ 571 kgf*cm , 41 ft.*lbf }



5. INSTALL SPEED SENSOR REAR LH
  1. Install the bolt, connect the speed sensor rear LH.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

    NOTICE:
    1. Be careful not to damage the speed sensor.
    2. Prevent foreign matter from attaching to the speed sensor.
    3. Do not twist the sensor wire when installing the sensor.



6. INSTALL REAR DISC


7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH
  1. Install the rear disc brake caliper assembly LH with the 2 bolts.

    Torque:
    88 N*m{ 900 kgf*cm , 65 ft.*lbf }



8. INSTALL REAR AXLE SHAFT LH NUT
  1. Clean the threaded parts on the drive shaft and rear axle shaft nut using a non-residue solvent.

    NOTICE:
    1. Be sure to perform this work for a new drive shaft.
    2. Keep the threaded parts free of oil and foreign objects.



    C089301
  1. Install a new axle shaft nut.

    Torque:
    216 N*m{ 2,200 kgf*cm , 159 ft.*lbf }

  1. Using a chisel and hammer, stake the axle shaft nut.



9. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



10. CHECK ABS SPEED SENSOR SIGNAL
  1. ABS WITH EBD & BA & TRAC & VSC SYSTEM (Click here).