Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Light Control Switch Circuit

for Preparation Click here


DESCRIPTION

This circuit detects the state of the headlight dimmer switch.

WIRING DIAGRAM


E142647E01


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Body / Data List.

  1. Read the display on Techstream.

    Body: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Dimmer Hi SW
    Dimmer switch HIGH signal / ON or OFF
    ON: Dimmer switch in HIGH or HIGH FLASH
    OFF: Dimmer switch in LOW
    -
    Passing Light SW
    Dimmer switch HIGH FLASH signal / ON or OFF
    ON: Dimmer switch in HIGH FLASH
    OFF: Dimmer switch not in HIGH FLASH
    -
    Front Fog Light SW
    Front fog light switch signal / ON or OFF
    ON: Fog light switch ON
    OFF: Fog light switch OFF
    -
    Light Auto SW
    Light control switch AUTO signal / ON or OFF
    ON: Light control switch in AUTO
    OFF: Light control switch not in AUTO
    -
    Headlight SW
    Light control switch HEAD signal / ON or OFF
    ON: Light control switch in HEAD
    OFF: Light control switch not in HEAD
    -
    Taillight SW
    Light control switch TAIL signal / ON or OFF
    ON: Light control switch in TAIL or HEAD
    OFF: Light control switch in neither TAIL nor HEAD
    -

    OK:
    Normal conditions listed above are displayed.



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY
  1. Inspect headlight dimmer switch assembly (Click here).



NG
REPLACE HEADLIGHT DIMMER SWITCH ASSEMBLY
OK


3.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


  1. Remove the instrument panel junction block assembly.


    E067348E13



  1. Measure voltage between the each of terminals as shown in the chart below.


    E067349E07


    Voltage:

    Tester Connection
    Condition
    Specified Condition
    1N-2 - Body ground
    Headlight dimmer switch LOW → HIGH
    10 to 14 V → Below 1 V
    B6-15 - Body ground
    Headlight dimmer switch LOW → FLASH
    10 to 14 V → Below 1 V
    B6-16 - Body ground
    Light control switch OFF → AUTO
    10 to 14 V → Below 1 V
    B6-17 - Body ground
    Light control switch OFF → TAIL
    10 to 14 V → Below 1 V
    B6-22 - Body ground
    Fog lamp switch OFF → ON
    10 to 14 V → Below 1 V
    B6-23 - Body ground
    Light control switch OFF → HEAD
    10 to 14 V → Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE