Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Illumination Circuit

for Preparation Click here


DESCRIPTION

The Multiplex network body ECU controls illumination light as shown in the chart below.
  1. Room light assembly (Interior light, luggage component light) and courtesy light with DOOR position
  2. Map light assembly (Personal light)
  3. Transponder key amplifier (Ignition key cylinder light)

WIRING DIAGRAM


E115592E04


E115593E05


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Body / Active Test.

  1. Check the operation.

    Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Illuminated Entry System
    Interior light and Key illumination (Interior light SW is in Door position and all doors are closed)
    ON / OFF
    -



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
OK


2.INSPECT LIGHT CONTROL RELAY


    B016200
  1. Inspect interior dome light relay continuity.

    Resistance:
    Condition
    Tester connection
    Specified Condition
    Always
    3 - 5
    10 kΩ ro higher
    Apply B+ between the terminal 1 and 2
    3 - 5
    Below 1 Ω



NG
REPLACE LIGHT CONTROL RELAY
OK


3.INSPECT INTERIOR DOME LIGHT SWITCH ASSEMBLY


    I035771
  1. Check that there is resistance between the terminals at each switch position as shown in the chart.

    Resistance:
    Switch operation
    Tester connection
    Specified Condition
    OFF
    8 - 7
    9 - 7
    10 - 7
    10 kΩ ro higher
    DOOR
    5 - 10
    6 - 9
    7 - 8
    Below 1 Ω
    ON
    7 - 8 - 9 - 10
    Below 1 Ω



NG
REPLACE INTERIOR DOME LIGHT SWITCH ASSEMBLY
OK


4.INSPECT INTERIOR LIGHT
  1. Inspect the each of interior light (Click here).



NG
REPLACE INTERIOR LIGHT
OK


5.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


  1. Measure voltage between each of the terminals as shown in the chart below.


    E067349E12


    Voltage:

    Tester connection
    Condition
    Specified voltage
    1H-30 - Body ground
    All doors are closed → any door is open
    10 to 14 V → Below 1 V
    B7-9 - Body ground
    All doors are closed → open
    10 to 14 V → Below 1 V
    B9-13 - Body ground
    Front driver's door is closed → open
    10 to 14 V → Below 1 V
    B7-24 - Body ground
    Front passenger's door is closed → open
    10 to 14 V → Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE