DISTANCE CONTROL ECU > INSTALLATION |
| 1. INSTALL DISTANCE CONTROL ECU ASSEMBLY |
![]() |
Using a torque wrench, install the bolt.
Engage the clip.
| 2. INITIALIZE DISTANCE CONTROL ECU |
Be sure to perform the following procedures after replacing the distance control ECU.
Turn the ignition switch to the on position.
Turn the cruise main switch on.
With the brake pedal depressed, push the cruise control main switch to RES/ACC 3 times within 3 seconds. Check that the buzzer sounds at this time.
Perform any of the following to cancel beam axis adjustment mode.