Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER WITH COIL SPRING

FRONT SHOCK ABSORBER WITH COIL SPRING > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING
  1. Install the front shock absorber with coil spring as shown in the illustration.



    F044630
  1. Install the 3 nuts to the upper side of the front shock absorber with coil spring.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }



    F013683
  1. Install the 2 bolts and 2 nuts to the lower side of the front shock absorber with coil spring.

    Torque:
    210 N*m{ 2,140 kgf*cm , 155 ft.*lbf }

    NOTICE:
    When installing the bolt, hold the nut not to rotate.



    F044629
  1. Fully tighten the lock nut.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



    C065925
  1. Install the front flexible hose No.1 and speed sensor front LH with the bolt.

    Torque:
    19 N*m{ 189 kgf*cm , 14 ft.*lbf }



2. INSTALL FRONT STABILIZER LINK ASSEMBLY LH


    F045196
  1. Install the front stabilizer link assembly LH with the nut.

    Torque:
    74 N*m{ 755 kgf*cm , 55 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.



3. INSTALL COWL TOP PANEL SUB-ASSEMBLY OUTER FRONT


    F049306E01
  1. Install the cowl top brace and cowl top panel sub-assembly outer front with the 9 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Connect the wire harness to the cowl top panel sub-assembly outer front.



4. INSTALL WINDSHIELD WIPER MOTOR & LINK ASSEMBLY

HINT:
(Click here)



5. INSTALL FR WIPER ARM LH

HINT:
(Click here)



6. INSTALL FR WIPER ARM RH

HINT:
(Click here)



7. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



8. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT:
(Click here)