REAR SHOCK ABSORBER > INSTALLATION |
| 1. INSTALL SHOCK ABSORBER ASSEMBLY REAR LH |
![]() |
Install the rear spring bumper No.1 LH to the shock absorber assembly LH.
![]() |
Support the rear axle beam assembly with a jack.
Install the rear shock absorber assembly rear LH, cushion retainer and nut to the rear axle beam.
![]() |
Install the rear shock absorber cushion No.1 and rear shock absorber LH cushion retainer.
Temporary tighten a new lock nut.
![]() |
Using a 6mm hexagon wrench to hold the piston rod, fully tighten the lock nut.
| 2. INSTALL REAR SHOCK ABSORBER CAP LH |
![]() |
Install the shock absorber cap LH as shown in the illustration.
![]() |
Install the shock absorber head cover.
| 3. INSTALL REAR WHEEL |
| 4. FULLY TIGHTEN SHOCK ABSORBER ASSEMBLY REAR LH |
![]() |
Stabilize the shock absorber assembly rear LH.
If it is impossible to tighten the nut at this position, support the rear axle beam with a jack and load the rear compartment with a mass of approximately 90 kg (198 lb).
![]() |
Fully tighten the nut.
| 5. INSPECT REAR WHEEL ALIGNMENT |