Home › STEERING › POWER STEERING › RACK AND PINION POWER STEERING GEAR

RACK AND PINION POWER STEERING GEAR > INSTALLATION

for Preparation Click here



1. INSTALL RACK & PINION POWER STEERING GEAR ASSEMBLY


    D029979
  1. Install the power steering gear assembly with the 2 bolts and nuts.

    Torque:
    70 N*m{ 714 kgf*cm , 52 ft.*lbf }



2. CONNECT PRESSURE FEED TUBE ASSEMBLY


    D029970
  1. Connect the pressure feed tube assembly to the power steering gear assembly.

  1. Install the clip.



    D029977E01
  1. Using SST, connect the return tube assembly to the power steering gear assembly.

    SST
    09023-12701  

    Torque:
    22.5 N*m{ 229 kgf*cm , 17 ft.*lbf }

    HINT:
    1. Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
    2. This torque value is effective when SST is parallel to the torque wrench.



    D029974
  1. Install the tube clamp with the bolt.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }



    D029975
  1. Install the tube clamp with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }



3. INSTALL FRONT STABILIZER BRACKET NO.1 LH


    D030615E04
  1. Install the stabilizer bracket No. 1 with the 2 bolts.

    Torque:
    17 N*m{ 173 kgf*cm , 12 ft.*lbf }



4. INSTALL FRONT STABILIZER BRACKET NO.1 RH

HINT:
Perform the same procedure on the other side.



5. INSTALL FRONT STABILIZER LINK ASSEMBLY LH


6. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedure on the other side.



7. INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY


    D029986E04
  1. Align matchmarks on the intermediate shaft assembly and power steering gear assembly.

  1. Install the bolt.

    Torque:
    36 N*m{ 367 kgf*cm , 27 ft.*lbf }



    D030704E04
  1. Install the dust cover.

    HINT:
    Ensure that the springs are installed tightly.



8. INSTALL TIE ROD ASSEMBLY LH


9. INSTALL TIE ROD ASSEMBLY RH

HINT:
Perform the same procedure on the other side.



10. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



11. INSPECT CENTER FRONT WHEEL


12. INSPECT STEERING WHEEL CENTER POINT


13. ADD POWER STEERING FLUID


14. BLEED POWER STEERING FLUID

HINT:
(Click here)



15. INSPECT FOR POWER STEERING FLUID LEAK


16. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT:
(Click here)