FRONT SEAT OUTER BELT ASSEMBLY > DISPOSAL |
| 1. DISPOSE OF FRONT SEAT OUTER BELT ASSEMBLY (WHEN INSTALLED IN VEHICLE) |
Disconnect the cable from negative battery terminal.
![]() |
Check the function of SST.
![]() |
Connect the SST red clip to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.
![]() |
Press the SST activation switch, and check that the LED of the SST activation switch lights up.
Disconnect the SST from the battery.
Disconnect the pretensioner connector (Click here).
Connect the SST.
Install the floor anchor of the seat belt.
![]() |
Connect 2 SST, then connect them to the front seat outer belt pretensioner.
![]() |
Move the SST at least 10 m (33 ft.) away from the front of the vehicle.
Close all the doors and windows of the vehicle.
Connect the SST red clip to the battery positive (+) terminal and the black clip to the negative (-) terminal.
Activate the seat belt pretensioner.
Confirm that no one is inside the vehicle or within 10 m (33 ft) of the vehicle.
Press the SST activation switch and activate the seat belt pretensioner.
Dispose of the front seat outer belt assembly (with the seat belt pretensioner).
| 2. DISPOSE OF FRONT SEAT OUTER BELT ASSEMBLY (WHEN NOT INSTALLED IN VEHICLE) |
Remove the front seat outer belt (Click here).
![]() |
Check the function of SST.
![]() |
Connect the SST red clip to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.
![]() |
Press the SST activation switch, and check that the LED of the SST activation switch lights up.
Connect SST.
![]() |
Connect 2 SST, then connect them to the front seat outer belt pretensioner.
![]() |
Place the front seat outer belt assembly on the ground and cover it with a wheel with tire.
![]() |
Move the SST at least 10 m (33 ft.) away from the disc wheel.
Activate the seat belt pretensioner.
Connect the SST red clip to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.
Check that no one is within 10m(33 ft) of the wheel.
Press the SST activation switch and activate the seat belt pretensioner.
Dispose of the front seat outer belt (with the seat belt pretensioner).
Remove the wheel and SST from the front seat outer belt.
![]() |
Place the front seat outer belt in a plastic bag, tie the end tightly and dispose of it in the same way as other general parts.