Home › RESTRAINTS › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY

FRONT SEAT OUTER BELT ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working (Click here).



2. REMOVE FRONT SEAT ASSEMBLY

HINT:
  1. Refer to the instructions for removal of the front seat assembly (for flat type) (Click here).
  2. Refer to the instructions for removal of the front seat assembly (for manual seat) (Click here).
  3. Refer to the instructions for removal of the front seat assembly (for power seat) (Click here).



3. REMOVE FRONT DOOR SCUFF PLATE


    B066491E01
  1. Using a screwdriver, disengage the 3 clips and 2 claws, and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE REAR DOOR SCUFF PLATE


    B066493E01
  1. Using a screwdriver, disengage the 8 clips and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE FRONT DOOR WEATHERSTRIP


6. REMOVE REAR DOOR WEATHERSTRIP

HINT:
When reinstalling the weatherstrip, completely remove the sealer adhering to the opening flange on the body side beforehand.



7. REMOVE CENTER PILLAR LOWER GARNISH


    B066509
  1. Remove the floor anchor cover.

  1. Remove the bolt and disconnect the front seat outer belt on the floor anchor side.



    B066496E01
  1. Using a screwdriver, disengage the 5 clips and remove the pillar garnish.

    HINT:
    Tape the screwdriver tip before use.

  1. w/ power slide door:
    Disconnect the power slide door control switch RH connector.



8. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

NOTICE:
  1. Removal operation concerning the seat belt with the pretensioner must be started in 90 seconds or more after the ignition switch is turned OFF and the battery negative terminal is disconnected.
  2. Carefully read the notices for the "pretensioner" in the SRS airbag system and the outer belt assembly.

  1. Remove the floor anchor cover.

  1. Remove the bolt and the front seat outer belt assembly on the floor anchor side.

  1. Remove the nut and the front seat outer belt assembly on the shoulder anchor side.



    B069495
  1. Disconnect the pretensioner connector, as shown in the illustration.

  1. Remove the 2 bolts and front seat outer belt assembly.



9. REMOVE CENTER PILLAR UPPER GARNISH


    B066498E01
  1. Using a screwdriver, disengage the assist grip plugs.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the 2 torx screws and assist grip No. 2 RH.



    B066497
  1. Remove the 3 bolts.

  1. Using a screwdriver, disengage the clip and remove the pillar garnish.

    HINT:
    Tape the screwdriver tip before use.



10. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
  1. Remove the bolt and front shoulder belt anchor adjuster assembly.