Home › BODY › SEAT › FRONT SEAT ASSEMBLY (for Power Seat)

FRONT SEAT ASSEMBLY (for Power Seat) > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SEAT ASSEMBLY LH


    B089352
  1. Place the seat assembly in the cabin.

    NOTICE:
    Be careful not to damage the body.

  1. Connect the connectors under the seat assembly.

  1. Tighten the 2 bolts on the front side of the seat assembly.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

  1. Tighten the 2 bolts on the rear side of the seat assembly.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

  1. Install the 2 seat track covers.



2. INSTALL FRONT SEAT HEADREST ASSEMBLY


3. CHECK SRS WARNING LIGHT

HINT:
Click here



4. INSPECT POWER SEAT OPERATION


    B113023E01
  1. Check the basic functions.

    1. Operate the power seat switches and check the following seat functions:

      1. Sliding
      2. Reclining
      3. Front vertical (Driver side seat only)
      4. Lifter (Driver side seat only)
      5. Lumbar support (Driver side seat only)



5. CHECK SEAT HEATER OPERATION


    B088526E01
  1. Disconnect the connector from the seat heater control.

  1. Measure the voltage and resistance of each terminal of the wire harness side connector.

    Standard:
    Tester Connection
    Condition
    Specified Condition
    1 - Body ground
    Always
    Below 1 Ω
    1 - 3
    Seat heater switch
    OFF → ON
    (Ignition switch ON)
    0 V → 11 to 14 V
    1 - 4
    Always
    11 to 14 V

    If the result is not as specified, there may be a malfunction on the wire harness side or the seat heater switch.



6. INITIALIZE OCCUPANT CLASSIFICATION SYSTEM

HINT:
Click here