DTC No.
| DTC Detection Condition
| Trouble Area
|
P0340
| - Input voltage to ECM remains 0.3 V or less, or 4.7 V or higher for more than 4seconds, when 2 or more seconds have elapsed after turning ignition switch to the ON position
(1 trip detection logic)
- Missing VVT sensor signal despite crankshaft position sensor inputs normal at engine speed of 600 rpm or more
(1 trip detection logic)
- No VVT sensor signal to ECM during cranking
(2 trip detection logic)
| - Open or short in VVT sensor circuit for intake camshaft
- VVT sensor for intake camshaft
- Camshaft timing gear for intake camshaft
- Jumped tooth of timing chain for intake camshaft
- ECM
|
P0342 P0347
| Output voltage of VVT sensor is 0.3 V or less for 4 seconds (1 trip detection logic)
| - Open or short in VVT sensor circuit for intake camshaft
- VVT sensor for intake camshaft
- Camshaft timing gear for intake camshaft
- Jumped tooth of timing chain for intake camshaft
- ECM
|
P0343 P0348
| Output voltage of VVT sensor is 4.7 V or more for 4 seconds (1 trip detection logic)
| - Open or short in VVT sensor circuit for intake camshaft
- VVT sensor for intake camshaft
- Camshaft timing gear for intake camshaft
- Jumped tooth of timing chain for intake camshaft
- ECM
|
P0345
| - Input voltage to ECM remains 0.3 V or less, or 4.7 V or higher for more than 5 seconds, when 2 or more seconds have elapsed after turning ignition switch to the ON position
(1 trip detection logic)
- Missing VVT sensor signal despite crankshaft position sensor inputs normal at engine speed of 600 rpm or more
(1 trip detection logic)
| - Open or short in VVT sensor circuit for intake camshaft
- VVT sensor for intake camshaft
- Camshaft timing gear for intake camshaft
- Jumped tooth of timing chain for intake camshaft
- ECM
|
Related DTCs
| P0340: VVT position sensor (Bank 1) range check / rationality P0340: Camshaft position / Crankshaft position misalignment (Bank 1) P0340: VVT position sensor (Bank 1) range check (Chattering) P0342: VVT position sensor (Bank 1) range check (low voltage) P0343: VVT position sensor (Bank 1) range check (high voltage) P0345: VVT position sensor (Bank 2) range check / rationality P0345: VVT position sensor (Bank 2) range check (Chattering) P0347: VVT position sensor (Bank 2) range check (low voltage) P0348: VVT position sensor (Bank 2) range check (high voltage)
|
Required Sensors / Components (Main)
| VVT position sensor (Bank 1 and 2)
|
Required Sensors / Components (Related)
| Crankshaft position sensor
|
Frequency of Operation
| Continuous
|
Duration
| 4 seconds: P0340 (Camshaft position sensor range check), P0340, P0342, P0343 (Camshaft position sensor range check (Chattering, Low voltage, High voltage)) P0345, P0347, P0348 (VVT sensor range check (Chattering, Low voltage, High voltage)) 5 seconds: Others
|
MIL Operation
| 2 driving cycles: P0340 (Camshaft position sensor range check) Immediate: Others
|
Sequence of Operation
| None
|