DTC P0505 Idle Control System Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0505 | Idling speed continues to vary greatly from target idling speed (2 trip detection logic) |
|

| Related DTCs | P0505: ISC Function |
| Required Sensors / Components (Main) | ETCS |
| Required Sensors / Components (Related) | Crankshaft position sensor, Engine coolant temperature sensor, and Vehicle speed sensor |
| Frequency of Operation | Continuous |
| Duration | 10 minutes |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| The monitor will run whenever these DTCs are not present | P0010, P0020 (OCV bank 1, 2) P0011, P0021 (VVT system bank 1, 2 - advance) P0012, P0022 (VVT system bank 1, 2 - retard) P0013, P0023 (Exhaust OCV bank 1, 2) P0014, P0024 (Exhaust VVT system bank 1, 2 - advance) P0015, P0025 (Exhaust VVT system bank 1, 2 - retard) P0016, P0018 (VVT system bank 1, 2 - misalignment) P0017, P0019 (Exhaust VVT system bank 1, 2 - misalignment) P0031, P0032, P0051, P0052 (A/F sensor heater) P0100, P0102, P0103 (MAF meter) P0115, P0117, P0118 (ECT sensor) P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2135 (TP sensor) P0125 (Insufficient ECT for closed loop) P0171, P0172, P0174, P0175 (Fuel system) P0301, P0302, P0303, P0304, P0305, P0306 (Misfire) P0335 (CKP sensor) P0340, P0342, P0343, P0345, P0347, P0348 (VVT sensor) P0351, P0352, P0353, P0354, P0355, P0356 (Igniter) P0365, P0367, P0368, P0390, P0392, P0393 (Exhaust VVT sensor) P0450, P0451, P0452, P0453 (EVAP system) P0500 (Vehicle speed sensor) P2195, P2196, P2197, P2198 (A/F sensor - rationality) P2237, P2240 (A/F sensor - open) P2238, P2241, P2252, P2255 (A/F sensor - low impedance) P2239, P2242, P2253, P2256 (A/F sensor - high impedance) P2A00, P2A03 (A/F sensor - slow response) |
| Engine | Running |
| Either of following conditions is met | Condition 1 or 2 |
| 1. Frequency that both of the following conditions (a) and (b) met | 5 times or more |
| (a) Engine RPM - target engine RPM | Less then -100 rpm, or more than 150 rpm |
| (b) Vehicle condition | Stop after vehicle was driven by 6.25 mph (10 km/h) or more |
| 2. Frequency that both of the following conditions (a) and (b) are met | Once |
| (a) Engine RPM - target engine RPM | Below -100 rpm, or more then 150 rpm |
| (b) IAC flow rate learning valve | 1.3 L/sec. or less, or 8.5 L/sec. or more |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0505) |
Connect the Techstream to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester on.
Select the following menu items: Powertrain / Engine and ECT / Trouble Code.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P0505 | A |
| P0505 and other DTCs | B |
|
| ||||
| A | |
| 2.CHECK PCV HOSE CONNECTIONS |
|
| ||||
| OK | |
| 3.CHECK INTAKE SYSTEM |
Check the intake system for vacuum leakage.
|
| ||||
| OK | |
| 4.CHECK THROTTLE VALVE |
Check the throttle valve condition.
|
| ||||
| OK | ||
| ||