DTC P0630 VIN not Programmed or Mismatch - ECM / PCM |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0630 |
| ECM |
| Related DTCs | P0630: VIN not programmed |
| Required Sensors / Components (Main) | ECM |
| Required Sensors / Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 0.325 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| The monitor will run whenever these DTCs are not present | None |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |
| VIN code | Not programmed |
| VIN code | Programmed |
| 1.READ CURRENT DTC |
Connect the Techstream to the DLC3.
Turn the ignition switch to the ON position and turn the tester on.
Select the following menu items: Powertrain / Engine and ECT / Trouble Code.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P0630 | A |
| P0630 and other DTCs | B |
|
| ||||
| A | |
| 2.INPUT VIN WITH TECHSTREAM |
| NEXT | |
| 3.READ CURRENT DTC |
Connect the Techstream to the DLC3.
Turn the ignition switch to the ON position and turn the tester on.
Select the following menu items: Powertrain / Engine and ECT / Trouble Code.
Read the DTCs again.
|
| ||||
| OK | ||
| ||