SFI SYSTEM > Air Intake Control Circuit |


| 1.PERFORM ACTIVE TEST USING TECHSTREAM (VSV FOR AICV) |
![]() |
Turn the ignition switch to the ON position and turn the Techstream on.
Select the following menu items: Powertrain / Engine and ECT / Active Test / Activate the VSV for AICS and operate the VSV for AICV.
Check the operation of the VSV when the VSV is operated by the Techstream.
| Tester Operation | Specified Condition |
| VSV is ON | Air from port E flows out through port F |
| VSV is OFF | Air from port E flows out through the air filter |
|
| ||||
| NG | |
| 2.CHECK VSV (FOR AICV) |
Inspect the intake air control valve assembly (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (VSV FOR AICV - ECM) |
![]() |
Check the wire harness between the VSV for AICV connector and the ECM connector.
Disconnect the V2 VSV for AICV connector.
Disconnect the E9 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| VSV for AICV (V2-2) - AICV (E9-27) | Below 1 Ω |
| Tester Connection | Specified Condition |
| VSV for AICV (V2-2) or AICV (E9-27) - Body ground | 10 kΩ or higher |
Reconnect the ECM connector.
|
| ||||
| OK | |
| 4.INSPECT FUSE (EFI NO. 2 FUSE) |
![]() |
Check the EFI No. 2 fuse.
Remove the EFI No. 2 fuse from the engine room junction block.
Measure the EFI No. 2 fuse resistance.
Reinstall the EFI No. 2 fuse.
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (VSV FOR AICV - EFI RELAY) |
![]() |
Check the wire harness between the VSV for AICV and the EFI relay.
Remove the EFI relay from the engine room junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| VSV for AICV (V2-1) - EFI relay terminal (3) | Below 1 Ω |
Reconnect the VSV for AICV connector.
Reinstall the EFI relay.
|
| ||||
| OK | |
| 6.INSPECT VACUUM TANK |
Inspect the vacuum tank (Click here).
|
| ||||
| OK | ||
| ||