Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM

DYNAMIC LASER CRUISE CONTROL SYSTEM > Laser Sensor Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the laser sensor. The laser sensor emits radio waves towards an object in front and measures the distance and direction of the object by receiving the beam reflections. Based on the reflections, the sensor calculates the difference in speed between the vehicle and the object in front. This data is transmitted to the distance control ECU. The ECM recognizes the laser sensor via terminals LGND. If an open circuit occurs in the wire harness between terminals LGND, the ECM cannot recognize the laser sensor. The ECM will stop the control of the vehicle-to-vehicle distance control mode and only the constant speed control mode can be used.

WIRING DIAGRAM


E134982E06


INSPECTION PROCEDURE

1.CHECK DISTANCE CONTROL ECU (IGB VOLTAGE)


    I044453E06
  1. Disconnect the laser sensor connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    L1-5 (IGB) - Body ground
    Ignition switch ON
    10 to 14 V



NG
Go to step 3
OK


2.CHECK HARNESS AND CONNECTOR (LASER SENSOR - ECM AND BODY GROUND)


    I044455E09
  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E4-31 (LGND) - L1-1 (LGND)
    Always
    Below 1 Ω
    L1-1 (LGND) - Body ground
    Always
    10 kΩ or higher
    L1-2 (SGND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

3.CHECK HARNESS AND CONNECTOR (LASER SENSOR - DISTANCE CONTROL ECU)


    I044456E07
  1. Disconnect the distance control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L1-5 (IGB) - D2-13 (IGB)
    Always
    Below 1 Ω
    D2-13 (IGB) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE DISTANCE CONTROL ECU (Click here)