Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM

DYNAMIC LASER CRUISE CONTROL SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of the problem symptom. The likely causes of the problem are indicated in descending order. Check each suspected area in order. Repair or replace faulty parts or perform adjustments as necessary.
  2. Inspect the fuse and relay related to this system before inspecting the suspected areas below.


Dynamic Laser Cruise Control System: 
Symptom
Suspected Area
See page
Main switch cannot be turned on. (CRUISE main indicator light on combination meter does not illuminate.)
Cruise control switch circuit
Click here
CRUISE main indicator light circuit
Click here
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM.
Click here
Vehicle speed setting cannot be done. (CRUISE main indicator light on combination meter illuminates when main switch is turned on, but turns off when operating SET function.)
Cruise control switch circuit
Click here
If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM.
Click here
Vehicle speed setting cannot be done. (CRUISE main indicator light on combination meter illuminates when main switch is turned on, and remains on when operating SET function.)
Cruise control switch circuit
Click here
Stop light switch circuit
Click here
Transmission range sensor circuit (U151E)
Click here
Transmission range sensor circuit (U151F)
Click here
Vehicle speed sensor circuit
Click here
Combination meter system
Click here
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM.
Click here
While vehicle is driven with cruise control, the control is canceled. (CRUISE main indicator light remains on.)
Cruise control switch circuit
Click here
Vehicle speed sensor circuit
Click here
Stop light switch circuit
Click here
Combination meter system
Click here
Transmission range sensor circuit (U151E)
Click here
Transmission range sensor circuit (U151F)
Click here
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM.
Click here
Hunting (Speed is not constant.)
Vehicle speed sensor circuit
Click here
If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM.
Click here
Vehicle speed setting cannot be canceled. (When coast, acceleration, resume, or set speed change function is operated with control switch.)
Cruise control switch circuit
Click here
If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM.
Click here
Erroneous detection or lost sight of the vehicle ahead.
Clean laser sensor with soft cloth, etc.
-
Improper aiming of sensor beam axis
Click here
Alarm buzzer does not sound.
Skid control buzzer circuit
Click here
VSC system
Click here
Distance control ECU power source circuit
Click here
Distance control ECU
Click here
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM.
Click here
Set distance cannot be changed.
Combination meter system
Click here
Distance control switch circuit
Click here
Distance control ECU
Click here
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM.
Click here
No information on the display
Combination meter system
Click here
If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM.
Click here
No brake control (when decelerating)
VSC system
Click here
Distance control ECU power source circuit
Click here
Distance control ECU
Click here
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM.
Click here
Constant speed mode cannot be turned on.
Cruise control switch circuit
Click here
Combination meter system
Click here
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM.
Click here
Vehicle speed setting cannot be canceled with wiper HI or LO.
Wiper signal circuit
Click here
Distance control ECU
Click here
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM.
Click here
Vehicle speed setting is canceled with washer ON.
Washer signal circuit
Click here
Distance control ECU
Click here
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM.
Click here
Unable to adjust (complete) beam axis of laser sensor.
Check position, distance and angle of reflector
Click here
Check installation of laser sensor
Click here
Laser sensor
Click here
Distance control ECU
Click here
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM.
Click here
Cannot change from constant speed control mode to vehicle-to-vehicle distance control mode.
Cruise control switch circuit
Click here
Laser sensor power source circuit
Click here
Distance Control ECU
Click here
If the symptoms still occur after the above areas have been inspected and have proven to be normal, replace the ECM.
Click here
The CRUISE main indicator light remains blinking.
TC and CG terminal circuit
Click here
If the symptoms still occur after the above area has been inspected and has proven to be normal, replace the ECM.
Click here