DTC P0606 ECM / PCM Processor |
| DTC | DTC Setting Condition | Trouble Area |
| P0606 |
|
|
| Related DTC | None |
| Required sensors/Components (main) | ECM |
| Required sensors/Components (sub) | Heated oxygen sensor |
| Frequency of Operation | Continuous |
| Duration | 60 seconds |
| MIL Operation | Immediately |
| Sequence of Operation | None |
| Monitor runs whenever the following DTCs are not present | None |
| Engine | Running |
| Estimated heated oxygen sensor temperature | 450 to 800°C (842 to 1472°F) |
| Difference of main accelerator pedal position and sub accelerator pedal position | 0.3 V or more |
| Difference of main throttle position and sub throttle position | 0.3 V or more |
| Difference of main brake switch signal and sub brake switch signal | Different |
| Cruise control | Fail |
| heated oxygen sensor transistors | Fail |
| 1.CHECK ANY OTHER DTCS OUTPUT |
Connect the Techstream to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P0606 is output | A |
| DTC P0606 and P0136, P0137, P0138, P0156, P0157 or P0158 are output | B |
|
| ||||
| B | |
| 2.INSPECT DTC (P0136, P0137, P0138, P0156, P0157 OR P0158) |
Inspect the P0136, P0137, P0138, P0156, P0157 or P0158 flow chart.
|
| ||||
| 3.CHECK FOR EXHAUST GAS LEAK |
Allow the engine to idle and rev the engine.
Check for exhaust gas leaks around the heated oxygen sensor.
If any exhaust gas leaks are present, repair it and proceed to step 4. If no exhaust gas leaks are present, proceed to step 4.
| NEXT | |
| 4.PERFORM CONFIRMATION DRIVING PATTERN |
Clear the DTC (Click here).
Connect the Techstream to the DLC3.
Warm up the engine until the engine coolant temperature becomes 75° (167°F) or more.
Perform the driving pattern.

Accelerate the vehicle until 50 mph (80 km/h) and stop the vehicle.
Drive the vehicle by 35 to 50 mph (60 to 80 km/h) for 5 minutes or more.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P0606 and P0136, P0137, P0138, P0156, P0157 or P0158 are output | A |
| DTC P0606 is output | B |
| DTC is not output | C |
|
| ||||
|
| ||||
| A | |
| 5.INSPECT DTC (P0136, P0137, P0138, P0156, P0157 OR P0158) |
Inspect the P0136, P0137, P0138, P0156, P0157 or P0158 flow chart.
| NEXT | |
| 6.INSPECT ECM |
Clear the DTC (Click here).
Stop the engine and wait for 30 minutes.
Connect the Techstream to the DLC3.
Start the engine and allow it to idle for 2 minutes.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P0606 is output | A |
| DTC is not output | B |
|
| ||||
| B | ||
| ||