Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P0657    Actuator Supply Voltage Circuit / Open

for Preparation Click here


DESCRIPTION

The ECM monitors the output voltage to the throttle actuator. This self-check ensures that the ECM is functioning properly. The output voltage is usually 0 V when the ignition switch is turned off. If the output voltage is higher than 7 volts when the ignition switch is turned off, the ECM will illuminate the MIL and set a DTC when the ignition switch is turned on.

DTC
DTC Detection Condition
Trouble Area
P0657
Throttle actuator power supply error
ECM

MONITOR STRATEGY


Related DTC
P0657: ETCS power supply
Required sensors/Components (main)
ECM
Required sensors/Components (sub)
Throttle actuator
Frequency of Operation
Once per driving cycle
Duration
1 second or more
MIL Operation
Immediate
Sequence of Operation
None

TYPICAL ENABLING CONDITIONS


Throttle actuator power supply voltage
7 V or more

TYPICAL MALFUNCTION THRESHOLDS


Monitor will run whenever this DTC is not present
None
Ignition switch
From ON to OFF

INSPECTION PROCEDURE

1.CHECK WHETHER DTC OUTPUT RECURS (IN ADDITION TO DTC P0657)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Turn the tester on.

  1. Clear the DTC.

  1. Turn the ignition switch off.

  1. Disconnect the battery negative terminal and wait for 1 minute.

  1. Connect the battery negative terminal.

  1. Turn the ignition switch to the ON position for 10 seconds.

  1. Turn the ignition switch off.

  1. Turn the ignition switch to the ON position.

  1. Enter the following menus: Powertrain / Engine and ECT / Trouble Code.

  1. Read the DTCs.

    Result:
    Display (DTC output)
    Proceed to
    P0657
    A
    No output DTC
    B



B
CHECK FOR INTERMITTENT PROBLEMS
A

REPLACE ECM (Click here)