LUBRICATION SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK ENGINE OIL LEVEL |
Warm up the engine, stop it and wait 5 minutes. The oil level should be between the dipstick's low level mark and full level mark.
If the engine oil level is low, check for leakage and add oil up to the full level mark.
| 2. CHECK ENGINE OIL |
Check the engine oil for deterioration, water contamination, discoloring or thinning.
If the oil is bad, replace the engine oil and engine oil filter.
| 3. CHECK OIL PRESSURE |
![]() |
Disconnect the oil pressure switch connector.
Using a 24 mm deep socket wrench, remove the oil pressure switch.
![]() |
Install the oil pressure gauge with adapter.
Warm up the engine.
Check the oil pressure.
| Engine Condition | Oil Pressure |
| Idle | 80 kPa (0.8 kgf/cm2, 11.6 psi) or more |
| 3000 rpm | 380 kPa (3.9 kgf/cm2, 55.5 psi) or more |
![]() |
Remove the oil pressure gauge.
Apply adhesive to 2 or 3 threads of the oil pressure switch.
![]() |
Using a 24 mm deep socket wrench, install the oil pressure switch.
Connect the oil pressure switch connector.
Check for engine oil leaks.