CAN COMMUNICATION SYSTEM > ECM Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| ECM Communication Stop Mode |
|
|

| 1.CHECK OPEN IN CAN BUS WIRE (ECU MAIN BUS WIRE) |
Disconnect ECM connector (E5).
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E5-33 (CANH) - E5-34 (CANL) | Ignition Switch off | 108 to 132 Ω |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (E1, BATT, +BM, IGSW) |
Connect the ECM connector (E5).
Disconnect the ECM connector (E11).
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E1 (E11-1) - Body ground | Always | Below 1 Ω |
Connect the ECM connector (E11).
Disconnect the ECM connector (E4).
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| +B (E4-1) - Body ground | Ignition Switch off | 9 to 14 V |
| +B2 (E4-2) - Body ground | Ignition Switch off | 9 to 14 V |
| IGSW (E4-9) - Body ground | Ignition Switch on | 9 to 14 V |
|
| ||||
| OK | ||
| ||