Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1440/98    Steering Angle Sensor Unusual Bank Angle Detected

for Preparation Click here


DESCRIPTION

The skid control ECU receives signals from the yaw rate and deceleration sensor via the CAN communication system.
The yaw rate sensor has a built-in deceleration sensor and detects the vehicle condition.
If there is trouble in the bus lines between the yaw rate and deceleration sensor and the CAN communication system, the DTCs U0123/62 (malfunction in CAN communication with the yaw rate sensor) and U0124/95 (malfunction in CAN communication with the deceleration sensor) are output.

DTC Code
DTC Detection Condition
Trouble Area
C1440/98
The skid control ECU detects that the vehicle is driving on a bank at an angle of 30 degrees or more.
Yaw rate and deceleration sensor

WIRING DIAGRAM

Refer to DTCs C1232/32, C1234/34, C1243/43, C1244/44, C1245/45 and C1381/97 .

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the brake actuator assembly, perform zero point calibration (Click here).
  2. Before proceeding with the inspection, explain to the customer that the vehicle driving record shows that the vehicle was driven on a bank at an angle of 30°, and confirm that this condition occurred.

HINT:
When U0123/62, U0124/95 and/or U0126/63 is output together with C1440/98, inspect and repair the trouble areas indicated by U0123/62, U0124/95 and/or U0126/63 first (Click here).

1.CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to the ON position again and check that no CAN communication system DTC is output (Click here).

  1. Drive the vehicle at a speed of 30 km/h (19 mph) or more, turn the steering wheel, and decelerate the vehicle (depress the brake pedal) and check that no yaw rate and deceleration sensor DTCs are output (Click here).

    Result:

    Result
    Proceed to
    DTC (C1440/98) is output
    A
    CAN communication system DTC is output
    B
    Yaw rate and deceleration sensor DTC is output
    C
    DTC (C1440/98) is not output
    D

    HINT:
    DTC C1440/98 may have been stored because the vehicle was driven on a bank at an angle of 30°or more.



B
INSPECT CAN COMMUNICATION SYSTEM

C
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS

D
CHECK FOR INTERMITTENT PROBLEMS
A


2.CHECK YAW RATE AND DECELERATION SENSOR INSTALLATION
  1. Turn the ignition switch off.

  1. Check that the yaw rate and deceleration sensor has been installed properly (Click here).

    OK:
    The sensor should be tightened to the specified torque.
    The sensor should not be installed in a tilted position.



NG
INSTALL YAW RATE AND DECELERATION SENSOR CORRECTLY
OK

REPLACE BRAKE ACTUATOR ASSEMBLY