Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



BUS CHECK
  1. Using the Techstream, select "CAN Bus Check" from the "System Select".


CHECK FOR INSTALLED SYSTEMS (ECUS AND SENSORS) THAT USE CAN COMMUNICATION
  1. Systems (ECUs, sensors) that use CAN communication vary depending on the vehicle's optional equipment. Check which systems (ECUs, sensors) are installed on the vehicle.

    ECU/Sensor name
    Check method
    ENGINE
    Installed on all vehicles
    GATEWAY
    Installed on all vehicles
    ABS/VSC/TRC*1
    With VSC system
    STEERING ANGLE SENSOR*1
    With VSC system
    YAW RATE/ DECELERATION SENSOR*1
    With VSC system
    DISTANCE CONTROL*2
    With dynamic laser cruise control system

    HINT:
    1. *1: with VSC
    2. *2: with Dynamic laser cruise control


DTC TABLE BY ECU

HINT:
  1. For the CAN communication system, CAN communication system DTCs stored in certain ECUs can be displayed using the Techstream.
  2. If CAN communication system DTCs are output, trouble cannot be determined only by the DTCs. Perform troubleshooting according to "CHECK CAN BUS LINE" (Click here).

  1. Skid control ECU (with VSC)

    HINT:
    DTC communication uses the CAN communication system.


    DTC No.
    Detection Item
    U0073
    Control Module Communication Bus OFF
    U0100
    Lost Communication with ECM
    U0123
    Lost Communication with Yaw Rate Sensor Module
    U0124
    Lost Communication with Yaw Rate Sensor Module
    U0126
    Lost Communication with Steering Angle Sensor Module

  2. ECM (with Dynamic laser cruise control)

    HINT:
    1. DTC communication uses the CAN communication system.
    2. Distance control ECU data is output.
    3. Displayed on the "communication malfunction DTCs" screen of the Techstream. If U0235 or U1102 is output alone, the CAN communication is normal (Click herefor U0235, Click here for U1102).


    DTC No.
    Detection Item
    U0100
    1. Lost Communication from ECM to Distance Control ECU
    2. Lost Communication from ECM to Skid Control ECU
    U0122
    Lost Communication from Skid Control ECU to ECM
    U0123
    Lost Communication with Yaw Rate Sensor Module
    U0126
    Lost Communication with Steering Angle Sensor Module
    U1101
    Lost Communication with Driving Support ECU

  3. Gateway ECU

    HINT:
    The network gateway ECU is connected to the CAN communication system, but CAN communication DTCs are not output.


DTCS COMBINATION TABLE

DTC
Trouble Mode
Output from
Output DTC
ECM Communication Stop Mode
Skid Control ECU Communication Stop Mode
Steering Angle Sensor Communication Stop Mode
Yaw Rate Sensor Communication Stop Mode
Distance Control ECU Communication Stop Mode
Skid Control ECU
U0073
-
○
-
-
-
U0100
○
○
-
-
-
U0123
-
○
-
○
-
U0124
-
○
-
○
-
U0126
-
○
○
-
-
ECM*1
U0100
○
-
-
-
○
U0122
-
○
-
-
○
U0123
-
-
-
○
○
U0126
-
-
○
-
○
U1101
-
-
-
-
○

HINT:
*1: with Dynamic laser cruise control