Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
85720D
1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY
Install the power window regulator motor assembly for the front door window regulator assembly (1) in direction of arrow so that its shaft (2) is fitted de-energized in the gearing (3) of the front door window regulator assembly.
Install the T25 screws (1).
69820
2.INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY
3. INITIALIZE POWER WINDOW CONTROL SYSTEM
When a power window regulator motor assembly replaced, the power window control system must be initialized. Functions such as the auto up and down function, jam protection function and window open warning function will not operate if initialization is not performed.
When performing initialization, use the power window switch of each door to initialize each power window.
Make sure to park the vehicle and all doors closed before performing initialization.
Operating procedure for initialization (manual):
Move front door glass sub-assembly into lower end position.
Press and hold switch in "Open one-touch function" position (second switch position) for a timespan between 15 and 25 seconds.
Move front door glass sub-assembly to upper end position.
Switch position "Close one-touch function" (2nd switch position) hold down the switch position during the entire process.
Connect the diagnosis system to the vehicle and enter the following menus:
Vehicle management / Service functions / Body / Locking and security functions / Power window regulator / Initialize power window drive