Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
87139C
1.INSTALL CLEAN AIR FILTER
Install the clean air filter (1) as shown in the illustration.
Please note that the arrow (1) on the clean air filter (2) must always point in the direction of travel during installation.
Make sure that the cover (3) is correctly inserted into the latch mechanisms (2) of the blower housing.
Tighten the T20 screws (1).
Connect drain cooler hose (1).
Insert the drain cooler hose (1) into the holder (2).
55607
2.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY