Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
Remove the front wiper arm head cap (1).
Using a socket wrench 16 mm , remove nut (2).
Using special tool 0 493 441 (61 6 060), pull off the front wiper arm and blade assembly LH (1).
2.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
Description is for left component only. Procedure on the right side is identical.
55878B
3.REMOVE COWL VENT COVER LH
Disengage the lock (1).
Remove cowl vent cover LH (2).
55877B
4.REMOVE COWL VENT COVER RH
for Type A:
Disconnect the connector and washer nozzle and hose assembly (1) from the cowl vent cover RH (3).
Disengage the lock (2).
Remove the cowl vent cover RH (3).
for Type B:
Disconnect the connector and washer nozzle and hose assembly (1) from the cowl vent cover RH (3).
Disengage the lock (2).
Remove the cowl vent cover RH (3).
53867
5.REMOVE FRONT FENDER TO COWL SIDE SEAL LH
Remove the clips (1).
Remove front fender to cowl side seal LH (2).
53866
6.REMOVE FRONT FENDER TO COWL SIDE SEAL RH
Description is for left component only. Procedure on the right side is identical.
55734A
7.REMOVE WATER GUARD PLATE RH
Disengage the claws (1) and guide (2) to remove the water guard plate RH.
55781E
8.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
Disengage the claws (2) to disconnect the cowl top ventilator louver sub-assembly (1).
Pull the cowl top ventilator louver sub-assembly (1) upward out of the claw (2) beginning on the side.
53681
9.REMOVE UPPER FRONT SUSPENSION CENTER BRACE
85010
10.REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY
Remove the nuts (1).
Disengage the guide (2).
Disengage the clamp (2).
Disconnect the connector (1) to remove the front wiper motor and link assembly (3).