Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › REAR DRIVE SHAFT ASSEMBLY
RM3650E _52 Drivetrain _079887 DRIVE SHAFT / PROPELLER SHAFT _0387616 REAR DRIVE SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  REAR DRIVE SHAFT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.

Danger! Life-threatening injuries!

-

Observe safety information on raising the vehicle using a vehicle hoist.




NOTICE:
·

Damage to rear axle differential.

Failure to comply with the oil specifications can result in serious damage to the rear axle differential.

-

After completion of repair work, check the differential oil level in the rear axle differential.

-

Use only the approved final drive differential oil.




PROCEDURE

Hide 41110 1.REMOVE REAR DIFERENTIAL CARRIER ASSEMBLY

Hide 42340B 2.REMOVE REAR DRIVE SHAFT ASSEMBLY

a.
C413558

Remove the sealing cap (1).


b.
C413559

Press brake pedal.


c.

Loosen the 17 mm hexagon bolt (1).


d.

Remove the rear drive shaft assembly towards the center of vehicle.