Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR
RM3650E _54 Brake _079888 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0387627 FRONT SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 89516F 1.INSTALL FRONT SKID CONTROL SENSOR WIRE

a.

Clean the bore hole for the front skid control sensor wire.


b.

Coat the bore hole for the front skid control sensor wire with NBU 12K Lubricating Grease.


c.

Install front skid control sensor wire.


d.

Replace the E11 bolt.


e.

Position and tighten the E11 bolt.

Torque:
11.8 N*m (120 kgf*cm, 9 ft.*lbf)


f.

Attach the cable of the front skid control sensor wire in the bracket.


g.
C418399

Connect the cable of the front skid control sensor wire in the brackets (1).


h.

Connect connectors and lock (2).


i.

Close the connection box.


Hide 2.INSTALL FRONT WHEEL