Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE REAR WHEEL
89516P
2.REMOVE REAR SKID CONTROL SENSOR WIRE
Unscrew the nut (1) in the area of the spring strut.
Slightly raise the rear wheel hose liner (2).
The wheel arch cover will not be removed.
Undo E11 bolt (2) and remove the rear skid control sensor wire.
Detach the rear skid control sensor wire cable from the brackets (1).
Detach the rear skid control sensor wire cable from the brackets (1).
Unlock plug connection (2) and disconnect.