Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR
RM3650E _54 Brake _079888 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0387628 REAR SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 89516P 1.INSTALL REAR SKID CONTROL SENSOR WIRE

a.

Clean the bore hole for the rear skid control sensor wire.


b.

Coat the bore hole for the rear skid control sensor wire with NBU 12K Lubricating Grease.


c.

Install rear skid control sensor wire.


d.

Replace the E11 bolt.


e.
C413649

Tighten down E11 bolt (2).

Torque:
11.8 N*m (120 kgf*cm, 9 ft.*lbf)


f.

Connect the cable of the rear skid control sensor wire in the brackets (1).


g.
C413650

Connect the cable of the rear skid control sensor wire (2) in the brackets (1).


h.

Connect connectors and lock.


i.

Position the rear wheel hose liner correctly.


j.

Tighten down nut.

Torque:
2.6 N*m (27 kgf*cm, 23 in.*lbf)


Hide 2.INSTALL REAR WHEEL