Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
84340
1.REMOVE STOP LIGHT SWITCH ASSEMBLY
47110
2.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY
Insert the special tool 2 409 646 between the brake pedal support assembly and brake booster assembly.
Apply support (1) of the special tool 2 409 646 on the bearing support. If necessary fix the position of the support by rotating the screw on the release tool.
Push release special tool 2 409 646 in the direction of the arrow and lever the brake pedal support assembly off the brake booster assembly.
Release both holders (1) and lay the cable (2) to one side.
for LHD:
Loosen nuts (1).
for RHD:
Loosen nuts (1).
Remove the bracket.
Release the bolt (1) and thread out the brake pedal support assembly (2).