Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL
RM3650E _54 Brake _079889 BRAKE SYSTEM (OTHER) _0387637 BRAKE PEDAL A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 47110 1.INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

a.

Insert the brake pedal support assembly.


b.

Replace the bolt.


c.

Tighten down bolt.

Torque:
21.4 N*m (218 kgf*cm, 16 ft.*lbf)


d.

Replace nuts.


e.

for LHD:

i.

Tighten the nuts.

Torque:
21.4 N*m (218 kgf*cm, 16 ft.*lbf)



f.

for RHD:

i.

Instrall the bracket.


ii.

Tighten the nuts.

Torque:
21.4 N*m (218 kgf*cm, 16 ft.*lbf)



g.

Position the cable and clip in the holder.


h.
C413631

Check the clamp (1) for damage; replace if necessary.


i.
C467188

Before installing the holding clip, push the ball socket (1) into the holding clip (2).


j.

Ball socket (1) must engage in a noticeable manner.


k.
C413632

Press the brake pedal support assembly in the direction of arrow and lock it with the brake booster assembly.

NOTICE:

The brake pedal support assembly must be completely locked with the brake booster assembly.



Hide 84340 2.INSTALL STOP LIGHT SWITCH ASSEMBLY