Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
84340
1.INSTALL STOP LIGHT SWITCH ASSEMBLY
Clip in the holder (3) of the stop light switch assembly into the brake pedal.
Press brake pedal.
Engage the stop light switch assembly (2) with the holder (3) of the stop light switch assembly up to the limit position.
Counter support the holder (3) of the stop light switch assembly and simultaneously relieve the brake pedal slowly and completely.
The brake pedal is moved back to the stop.
Connect the connector (1).
87211
2.INSTALL NO. 1 AIR DUCT
55606
3.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY