Use only approved brake fluids, see operating fluids.
Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
53681
1.REMOVE UPPER FRONT SUSPENSION CENTER BRACE
2.REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
Prerequisite
The brake fluid has been drawn off from the brake fluid expansion tank.
Unlock plug connection (1) and disconnect.
Loosen T20 bolt (1).
Remove master cylinder reservoir sub-assembly (2) upwards.
3.REMOVE MASTER CYLINDER BODY
Unfasten brake lines (1).
Loosen nuts (1).
Remove the master cylinder body (2).