Working on 12 V vehicle electrical system.
Risk of short circuits! Risk of fire!
Detach the cable from the negative (-) battery terminal.
Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or components.
When disconnecting the cable, turn the START-STOP button (engine switch) and headlight switch off and loosen the cable nut completely. Perform these operations without twisting or prying on the cable. Then disconnect the cable.
Clock settings, radio settings, audio system memory, DTCs and other data will be cleared when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable.
1.REMOVE REAR POWER DISTRIBUTION BOX
2.REMOVE SEMICONDUCTOR POWER INTEGRATION ECU
|
Slide in this Direction |
Press the marked area (1) to slide the locking bracket (2) in the direction of the arrow.
Remove the semiconductor power integration ECU (3) from the rear power distribution box.